Thingiverse
Reasonable Vases
door Zippitybamba
67
Downloads
50
Likes
0
Makes
There will be no unreasonable vases here. No sir.
If you are new to vases, you have 2 options:
1) Print as you normally do. You will get a solid model as is.
2) Set your slicer to vase mode. In Cura this is under special print modes, called "spiralize outer surface". The models here that have hollow spaces in the sides will *not* print properly in this mode.
These were generated from the attached OpenSCAD file. Give it a tinker.
If you are new to vases, you have 2 options:
1) Print as you normally do. You will get a solid model as is.
2) Set your slicer to vase mode. In Cura this is under special print modes, called "spiralize outer surface". The models here that have hollow spaces in the sides will *not* print properly in this mode.
These were generated from the attached OpenSCAD file. Give it a tinker.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!