MakerWorld
Garden
Zum Modell
Rebar Corner Mount
8
Downloads
12
Likes
2
Makes
I made this simple corner bracket that holds a piece of rebar upright. I attached it to the back corners of my large planter and put chicken wire between them to act as a trellis for my peas. Netting also would have worked.I pushed the rebar all the way to the bottom of the planter and just put one bracket at soil-level. It seems sturdy, but it might not be a bad idea to put one at the bottom as well. I already had stuff planted and didn't want to dig it up, so I didn't bother. We'll see if it matters. This mount attaches with two wood screws.Print SettingsPrinter Brand: AnycubicPrinter: All-metal MegaRafts: NoSupports: NoResolution: 0.3Infill: 40% GyroidFilament: Econofil by filaments.ca PLA Black Notes:I used PLA, but PETG or ASA would probably be a better idea if you have some. Category: Outdoor & Garden
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
