Thingiverse
Reborn 2 Table Surface Test
von gmetrolog
12
Downloads
11
Likes
0
Makes
This table surface test only for Reborn 2.
For for other printers, you need to manually change the X Y scale.
After printing, you can see the areas where the re-extrusion occurred - there is a bulge of the table, and where there is a gap between the lines - the failure of the table.
_______________________
Tinkoff card for donates: 5536 9139 1829 2133
For for other printers, you need to manually change the X Y scale.
After printing, you can see the areas where the re-extrusion occurred - there is a bulge of the table, and where there is a gap between the lines - the failure of the table.
_______________________
Tinkoff card for donates: 5536 9139 1829 2133
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
