Recess base for minis

So I love the capability of being able to print my own miniatures I just wish that the success rate was higher than 1 in 10! I also love the ability of being able to print my own bases but I don’t like the feather weight that you get from all the plastic. So I decided to make a base that has a recess on the underside allowing you to glue in a small coin or washer.

The base itself is 1” diameter or 25.4mm & is about1/8” think (3.175mm). The recess is ¾” in dia. (19.05mm) & about 3/32” deep (2.38125mm). I use the Fat Dragon profile to print these & you will need a Dremel tool & razor knife to clean out the recess of all the stringing that will occur from printing.

Anyway, the size of this base should work for games like D&D, Saga, etc.