Recliner Replacement Pull Handle

You can buy these for very little money on the internet's favorite auction site, but then you would be limited to black instead of fun colors. Also, if you print a replacement then you will have buy-in from your significant other that your 3D printer was a good investment.

The handhold attaches to the lever with an m4 flathead socket cap (15mm length)
Receptacle attaches to the frame with three number 4 screws
Receptacle screws into OSB (furniture) with two M3.5 screws
You can use an M5 bolt as the pivot point between the lever and frame
I reused the spring from my broken recliner handle, but a spring is not necessary

The lever and frame have significant loads on them, I printed them with five perimeters and 40% infill (in ASA).