Recurve sight v2.0

This is a remix of my original recurve sight design. I started this to use m4 screws for fine adjustment. I ended up deciding to remove the printed scale marks in favor of attaching a printed scale to the sight. I've found this to be more accurate than the original as well. It also should work identically for right or left handed archers.

You will need two m4 screws: an 80mm and a 35mm. You will need a locknut for each. The mount also uses an m4 thumb screw, I think I used a 10mm one but it hardly matters. Of course it also requires two flat head 10-24 screws (I used 1/2" ones) to attach to your riser.

To assemble the arm that holds the sight, insert the sight into the sight holder. Then insert the 35mm M4 screw and screw it through the threads in the sight. There is a hole on the other side that should just fit the locknut. Insert the locknut and screw the screw into it. When the screw hits the plastic parts of the locknut, the nut will start spinning. I used a pair of