Thingiverse
Hobby
Zum Modell
Red Hood Helmet - Small Printer
676
Downloads
554
Likes
4
Makes
This is a remix of Budwin's design to fit the smaller printers that are out there such as the Ender 3 (220 x 220). This was made to print as much in as little pieces as possible (4).
Most of the prints didn't require supports as they were able to lay flat to the build plate. The dome and the face needed supports but only in select places. I put the full size helmet .stl as well so that you can scale to your appropriate size.
The original file is here:
https://www.thingiverse.com/thing:4757926
Most of the prints didn't require supports as they were able to lay flat to the build plate. The dome and the face needed supports but only in select places. I put the full size helmet .stl as well so that you can scale to your appropriate size.
The original file is here:
https://www.thingiverse.com/thing:4757926
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
