Thingiverse
Red Rocket with Plume
von JBDaws
2.2k
Downloads
2.1k
Likes
24
Makes
I love Nico Kazz's rocket plume https://www.thingiverse.com/thing:2823726 but cannot get the rocket to print on my machine so started looking for a rocket that would print.
I replicated and added to the plume then I combined it with Shawn Rains fantastic rocket to get this result. Then I added the middle flame which you may find needs to be glued into place
I used 1cm brim as there is not much to hold the rocket to the base plate and added support just for the the middle of the rocket. No support or brim is needed for the plume.The tolerance is tight and you may need to do a bit of sanding to get it to snap together.
It is quite fun to see this model evolve and improve!
There are some really cool lamps that have been created for this rocket. Have a look at these two re-mixed versions:
https://www.thingiverse.com/thing:4381265
https://www.thingiverse.com/thing:4254929
Also a great idea for using less support materials here: https://www.thingiverse.com/thing:4357451
I replicated and added to the plume then I combined it with Shawn Rains fantastic rocket to get this result. Then I added the middle flame which you may find needs to be glued into place
I used 1cm brim as there is not much to hold the rocket to the base plate and added support just for the the middle of the rocket. No support or brim is needed for the plume.The tolerance is tight and you may need to do a bit of sanding to get it to snap together.
It is quite fun to see this model evolve and improve!
There are some really cool lamps that have been created for this rocket. Have a look at these two re-mixed versions:
https://www.thingiverse.com/thing:4381265
https://www.thingiverse.com/thing:4254929
Also a great idea for using less support materials here: https://www.thingiverse.com/thing:4357451
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!