MakerWorld
Other Hobby & DIY
Go to Model
Reddit Cube Keychain
0
Downloads
1
Likes
0
Makes
This cube keychain is a fun little tribute to Reddit, with the logo printed on five sides. It’s simple to make and doesn’t require any special settings—just load it up with your usual slicer settings, and you’re good to go. It’s a small, sturdy piece that you can easily carry around because of the in-built loop, adding a subtle nod to your favorite online community.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
