REDESIGNED: Rainbows & Clouds (NO AMS)

This is a model that is based on a design I saw on TinkerCAD, and has all the colours split apart to allow for printing without an AMS, plates #1-6. Plate #7 is the full model which can be printed with Two AMS units If you have two AMS units you can use this model instead > https://makerworld.com/en/models/585730#profileId-506919 VERSION UPDATES: Version 8 - June 2025 - I redesigned this model from the ground up, using Arches rather than Torus, which makes the connection point to the cloud vertical rather than angled, for easier assembly. Version 3 - Apr 20,2025 - With your feedback I have created a higher resolution version (the clouds no longer look pixelated) I made it easier to print the top and bottom shell, and corrected the Lamp socket & carrier. I hope you enjoy! Version 2 - Based on community feedback I have added a new plate which is the clouds as 1 piece, there is some bridging but 0% infill so there is little support to remove. Also the LED female & Male connector now fit a