Reed Case with Humidity Control

Reed Case (saxophone, clarinet) for up to six reeds, compatible with Boveda Size 8 humidity control pouches. Contains three parts, two case parts (bottom, top) and the reed clamp. The case parts close with magnets (see parts list) and the reed clamp is fitted into the bottom part. For getting the best fit, especially when printed with different filaments, a bit of sanding is recommended. It is also recommended to sand the top layers of the two case parts so they have a flat and smooth surface for a good seal. At the bottom part, in the middle, there is a dedicated area where the humidity pouch is stored. It is open on both sides so the air and humidity can be controlled from both sides and it doesn't interfere with the reeds. This area can be accessed when the reed clamp is removed and there is a cutout so the pouch can be removed easily. The reed clamp part can be stored in the lid when the pouch needs to be changed. It is recommended to print everything in PET-G for best printability