Thingiverse
Reel guide CR6-SE
von Elie56
11
Downloads
9
Likes
1
Makes
I created this part to center the filament spool on its support so that it stops moving every time the extruder pulls a little.
it is mounted directly on the axis of the original support.
Good print
it is mounted directly on the axis of the original support.
Good print
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!