Reflective Insert for Redshift Arclight Pro Pedals

**Custom-fit reflective inserts for Redshift Arclight Pro pedals, offering a low-maintenance, no-charge alternative that’s also less likely to be targeted by thieves.**

https://youtu.be/bYCJf2Lhezo

### 🧰 Materials (per reflector)
- 2x neodymium magnets (Ø 8 mm × 3 mm, with hole)
- 2x M3 × 10 mm countersunk screws (often included with the magnets)
- 1x piece of reflective sticker (e.g. 3M Scotchlite or similar), approx. **90 × 12 mm**

A **full setup for two pedals** uses 4 reflectors (2 per pedal), 8 magnets, 8 M3×10 screws, and reflective material — either as 4 individual strips or cut from a single larger sheet.

### 🖨 Printing
- Material: **PLA** or **PETG** (*PETG recommended for outdoor use*)
- Supports: **Touching build plate only** (minimal supports required)

### 🔧 Assembly
1. **Pre-thread the holes** in the printed part with a screw if needed.
2. Carefully **screw in the magnets** using M3 screws.
- Magnets can be brittle—avoid over tightening.
3. Check magnet polarity a