Slicer Discord
Rega P8 Stylus Protector – 3D-printbaar model van MakerWorld MakerWorld
Other Hobby & DIY

Rega P8 Stylus Protector

16 Downloads
5 Likes
12 Makes
Model downloaden
The Rega Planar 8 turntable has a cover that leaves the stylus exposed. If you are careful this is not an issue but accidents can happen especially if you have pets etc. I wanted some way to protect my Apheta 3 stylus whilst minimising the risk of damage whilst any protection was attached. I think I have found quite a practical solution. The protector is lowered down onto the tonearm and the clip is then applied around the arm. This is an easy print with no need for supports. I always use a gluestick on the bed. For the hinges just use short lengths of filament which you may need to hold in place with a dab of super glue.Boost MeHope you find this print useful. If you do please consider boosting me. Thank you
Categorie
Other Hobby & DIY
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
geen supports
Zonder supports Eendelig
Supports 0/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Lijmen
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

5 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie