Relay_Riser_V1

This object was made in Tinkercad as a quick fix to mount a 2-Relay module above components on a PCB.

Screw hardware is M3 to secure PCB to printed parts top and bottom, only 2 screws required for the top as there are hooks printed on the part.

This part prints vertically orientated and while I only printed a pair as shown in the images I chose to place these close together on the print bed and use a brim to make sure the first layer was well adhered to the build surface. (these are small and very narrow)

Hint: The height of the stand-off is 35mm. You should be able to scale the "Z" dimension on your slicer software to adjust this though at some point the "hook" that engages one end of the printed part to the pcb hole will not fit well, you will have to solve this issue post print.