Reloading Block V2 - Pegs

Alignment pins for my family of Reloading Blocks V2, uploaded as a set of 4 which is enough for 1 tray. Pins allow the loading blocks to nestle together with a physical fit for easier storage (if you'd rather not buy magnets). Every printer and filament can be a little different so the peg and hole tolerances can vary (and if you slice the model yourself, depending on your settings) so I offer three different pin diameters. Print and test to find the one that gives the fit you're looking for. All pins are long enough for the deepest reloading tray I make. Trim to length after installing, to get the exact fit you're looking for. NOTE: pegs are also a useful tool for the magnets. They can be used to adjust the magnet position, remove a magnet if it went in too far or you changed your mind, etc. Recommend using the Loose Fit profiles for that.