Thingiverse
REMIX Vive controllers stand
von stayplusx
1
Downloads
0
Likes
0
Makes
the original design is nice but i wanted a small stand so, i removed the rear vive logo and decreased the height by 25mm just so it fits the controllers nicely
no you wont be able to charge the controller
the idea behind this remix is just so i have somewhere to put the controllers
printing settings are same as original
but if you want mine:
infill 5% (gyroid)
layer height 0.2
brim (to ensure it sticks nicely and not warp) at line count 5
nozzle temp depend on your filament
enjoy
no you wont be able to charge the controller
the idea behind this remix is just so i have somewhere to put the controllers
printing settings are same as original
but if you want mine:
infill 5% (gyroid)
layer height 0.2
brim (to ensure it sticks nicely and not warp) at line count 5
nozzle temp depend on your filament
enjoy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!