Remixed FTX vantage spoiler

Remixed from EinProBlemo's design to fit the FTX vantage.

printed on a 15cm bed at with ABS at 0.2mm layer height, supports are needed. Took just over 2 hours to print and minimal clean up was required. fit the vantage with no further mods necessary.

Not sure it will survive a roll but we'll soon see!

EDIT: Turns out it handles rolls really well. Thought it would smash to pieces the first time it went over but it surprised me and survived several pretty good spins.......that is until I accidentally launched it 5 ft into the air off a hill and it landed spoiler first with enough force to snap the spoiler mounting bracket as well as the spoiler! very impressed with how well it took the punishment. Test printing a replacement spoiler mounting bracket I designed, will upload later if it works.