Thingiverse
Remixed Gargoyle on Plinth
von Callan82
15
Downloads
9
Likes
0
Makes
Added a plinth on the bottom to make this printable on my 3D printer. The previous version wasn't flat and Cura couldn't cope with it easily. Scaled so that the model is approx 8cm tall.
Not very elegant but I'll post up a better version if I make it up.
Not very elegant but I'll post up a better version if I make it up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!