Remixed SuperRose using M10 Threads

Update : here's a trick to make the grub nut go in easier. In your slicer, scale the grub screw in just the X & Y at around 0.95 (95%) while leaving the height Z at 1.0. This will make it easier for the threads to go in.

Note:
Use V2 versions of the base and rod if you want a more forgiving fit.
If you have an M10 grub screw, that can also be used to connect the rose to the stem - only if you can't get the printer to print screw threads properly.

------

Note that this prints with monoprice select mini - but use 0.175mm magic number for layer height instead of 0.2mm.

I don't like gluing parts and prefer to connect them with screws and threads. Preferably with threads I can print.

I took the SuperRose design, simplified the geometry a litte in Fusion 360, added some M10 threads and a grub screw and it appears to work.

Only the grub screw might need a brim for surface adhesion, all other pieces should print without any need for raft or brim.

There are two versi