Remixed Upright Case

First off, i would like to give credit to roblpetty for the original design. I would also like to say that I'm very new to CAD and used Fusion360 to remix the design but I botched the fan sizing so that's why they don't fit well and I'm not printing a second enclosure.

To start, I lengthened the whole assembly and made the body a bit wider to slide the PSU in easier. Then I moved the motherboard pegs more centrally.

I closed all the holes and started over. I added a bunch of air cooling slots just because, moved the power plug into the backside, I added a couple of rectangle holes on the bottom for the cables to run through and a single hole on top. I moved the power switch and display to the front of the machine and used a 6 inch micro USB extender to move the plugin to the top.

Finally, I added 2 fans because I already had them wired up. The PSU fan is 92mm and the motherboard is 80mm. But again I had issues with the sizing.

*NOTE* I already changed the PSU fan to a circ