Thingiverse
REMNANT 2
von itsblxnk
3
Downloads
7
Likes
0
Makes
Please share your makes in the comments!
I recommend printing the logo itself at any layer height you want but ideally the lower the better. Also use lighting infill just to save weight since it doesn't need to be heavy at all.
Print the stand with tree supports like I did in pictures above. Use somewhat denser infill for strength and weight.
POST PRINT
- I sanded it down and then just scraped the logo on the concrete alot to give it a rough look
- Then I used acrylic paint and paper towels and dabbed the paint on to make it look like it does in the official picture
- Lastly to add a shine like it has glow, I coated it with a thin layer of polyurethane
No hardware required.
Remixes encouraged
I recommend printing the logo itself at any layer height you want but ideally the lower the better. Also use lighting infill just to save weight since it doesn't need to be heavy at all.
Print the stand with tree supports like I did in pictures above. Use somewhat denser infill for strength and weight.
POST PRINT
- I sanded it down and then just scraped the logo on the concrete alot to give it a rough look
- Then I used acrylic paint and paper towels and dabbed the paint on to make it look like it does in the official picture
- Lastly to add a shine like it has glow, I coated it with a thin layer of polyurethane
No hardware required.
Remixes encouraged
itsblxnk veröffentlicht auch auf
6 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!