Thingiverse
Remote Control Holder with Hook
von flippmode
2
Downloads
1
Likes
0
Makes
Remote control holder for wall mounted under TV receiver stand that supports the stand being tilted.
Part 1 prints fine at 0.2mm layers, no support needed. Infill 10%+ (i used 25%)
Part 2 prints fine at 0.2mm layers, with supports. Infill 10%+ (i used 25%)
Printed on Di3
Feel free to modify as needed.
Part 1 prints fine at 0.2mm layers, no support needed. Infill 10%+ (i used 25%)
Part 2 prints fine at 0.2mm layers, with supports. Infill 10%+ (i used 25%)
Printed on Di3
Feel free to modify as needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
