Thingiverse
remote Holder
von ArnoldHenri
11
Downloads
4
Likes
0
Makes
A remote holder done to fit my four remote controls.
Fusion file joined if you want to change measure in order to fit yours.
Be sure to set the Zseam to a corner (I set it to back left corner).
Infill Grid at 20% in order to have no issue with base of the remote hole.
Fusion file joined if you want to change measure in order to fit yours.
Be sure to set the Zseam to a corner (I set it to back left corner).
Infill Grid at 20% in order to have no issue with base of the remote hole.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!