Renault Clio shift knob

This is a shift knob i made based on the Clio's IV shift knob and used this: https://www.thingiverse.com/thing:4815629
as a start.
Stock gear pattern silver plastic fits in flush with double sided tape underneath it but will need some trimming since i couldn't make the grooves required.
I tried to get it as close as i could to the real thing using meshmixer and i made it 5-10mm shorter.
Also has an 11mm hole and 4 holes for M4 grab screws to secure it. (I recommend tapping them first then screw in the screws , layers might get seperated if you go too hard)

Important: Print using ''Fuzzy skin'' in Cura under ''Experimental'' to get the texture , infill is up to you ,but PETG is recomended to withstand hot weather without melting.

Feel free to remix it and share it if anyone gets it more accurate

Have fun!