Thingiverse
Renault Megane E-tech cupholder
von K4Unl
12
Downloads
21
Likes
1
Makes
Just remixed this on request for somebody on facebook.
Will eventually print this for my own, but don't own the car just yet.
Will update the model with pictures once i've seen it validated.
The fusion 360 file has a parameter that determines the cup size. I've added two defaults as well.
This assumes that the two notches on the side are actually 5.3cm apart, as measured by somebody else.
Will eventually print this for my own, but don't own the car just yet.
Will update the model with pictures once i've seen it validated.
The fusion 360 file has a parameter that determines the cup size. I've added two defaults as well.
This assumes that the two notches on the side are actually 5.3cm apart, as measured by somebody else.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!