Repairable Bubble Light holder

**Major Update** (Jan 15, 2026)
Due to my having problems printing various colored versions of these lights and because I had problems with curling at the point where the two halves meet - causing an unsightly seam gap - I completely re-worked the design. It looks the same externally but I made some structural changes. The threads are now a 3rd part so that supports are not necessary at the seam. You still need to support the inside of the top dome but both seams can be printed on the bed, increasing flatness so a gap is less likely. This means I needed to thread both halves and join them with a 3rd part consisting of threads in both directions. These threads are the same as the old ones so parts made with the old STL should still mate with new STL files.

There are 3 sets of STL where the difference is the number of stripes. There are 6, 8, and 10 hole versions. They are essentially identical otherwise. If you mix up the tops/bottoms they will fit together. I suggest printin