Thingiverse
Replacement backboard for picture frames with stand
von Hambear
14
Downloads
59
Likes
0
Makes
[IMPORTANT NOTE - file is very small scale - needs to be scaled up by 100x for a standard 15x10cm picture frame]
Really simple replacement backer I made for a picture frame where the old backer/stand was knackered, because it was just cardboard.
Prints well face-down on FDM. I had some stringing in my print and some lumps, as I didn't clear the nozzle properly, but it wont be seen, so good enough.
Stand is intentionally as thin as possible, to cut down on weight/print time. You might want to re-enforce if you want a sturdier option.
Really simple replacement backer I made for a picture frame where the old backer/stand was knackered, because it was just cardboard.
Prints well face-down on FDM. I had some stringing in my print and some lumps, as I didn't clear the nozzle properly, but it wont be seen, so good enough.
Stand is intentionally as thin as possible, to cut down on weight/print time. You might want to re-enforce if you want a sturdier option.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
