Replacement guide combs for Remington clipper

Replacement clipper guides/combs for Remington HC5888. Sizes are: 6mm-ish, 9mm-ish, 12mm-ish and 15mm-ish. *** Added 3mm upon request. I'm in the learning stages of Autodesk Fusion and thought this would be a fun challenge, they are not identical to the real combs but works well enough, the cutting length are near their original equivalent but not perfect. The shape of the combs proved difficult to print with maintained strength which is why there are so much support material, through testing I found this to be the best compromise, the ugliest edges are not against skin and eventual roughness can be sanded off easily.Be careful when removing supports as to not break the stabilizing crossbar. Prints well enough in PLA but PET-G might be better in the long run, especially around the retaining clip. I have only tried these on the “Virtually indestructible” HC5888 but I believe they might be compatible with additional Remington models HC363, HC822, HC920, HC921, HC4031, HC4050, HC5010,