Replacement small clamp jaws

The clamps are small hobby ones which seem to be available in most hobby suppliers. I think they also come in a larger size, but this clamp is about 65 x 45 x 10 mm in size. The ends of these clamps seem to break off occasionally. Although the rest of the clamp is OK, seemed not cost effective to bin them, especially as any new clamps will probably have same issue. Direct measurements were made from original and test printed. A few tweaks and all OK. Don't bother with supports for the pivot hole, just run a small drill through the hole when 3D print finished. Hope it's of some use to you out there.