Thingiverse
Replicape case - poly design
von Jozef_Torok
1
Downloads
2
Likes
0
Makes
Case for Replicape (electronic board for 3D printing).
2x fan mount: 40x40 mm
Holes for M3 nuts for better screws holding.
Srews on top: M3x16 mm
Screws on bottom: M3x ** mm
** It depends on the thickness of the wall you attach it to.
2x fan mount: 40x40 mm
Holes for M3 nuts for better screws holding.
Srews on top: M3x16 mm
Screws on bottom: M3x ** mm
** It depends on the thickness of the wall you attach it to.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
