Thingiverse

Replicator 1 Extruder Cooler

von AK_Eric

29 Downloads

25 Likes

1 Makes

I designed this extruder cooler for my Replicator 1 based on one main need: I use a removable glass build plate affixed with springy metal clips. These clips stick up off the build platform and will hit anything slightly lower than the gantry. Because of this, I designed this to shoot a jet of air just below the tip of the nozzle, but keeping the whole apparatus above the base of the gantry.

It's designed to not need any additional hardware (other than a 24v 40mm fan) to install.

40mm fan duct cooler extruder extruder cooler fan fan duct PLA print cooler replicator replicator original replicator1

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PLA

Nachbearbeitung

Hardware

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Replicator 1 Extruder Cooler

Zur Sammlung hinzufügen