Thingiverse
Replicator 2 Dial Indicator Holder
von bobpony
8
Downloads
7
Likes
0
Makes
Needed a slightly different design of the original. This version has a pocket to hold the nut in place (I'm not sure how the original stayed in place). It also has a larger hole for the dial indicator, it's 11mm now. This was necessary to accommodate the Triton dial indicator I purchased from Amazon:
https://www.amazon.com/gp/product/B016R3GLB0/ref=oh_aui_detailpage_o01_s01?ie=UTF8&psc=1
Note that the pocket for the nut runs upwards at a 30 degree angle, so you'll want to insert the nut into the pocket with the the flats of the nut parallel to horizontal. You should then be able to press it all the way down into the angled pocket.
https://www.amazon.com/gp/product/B016R3GLB0/ref=oh_aui_detailpage_o01_s01?ie=UTF8&psc=1
Note that the pocket for the nut runs upwards at a 30 degree angle, so you'll want to insert the nut into the pocket with the the flats of the nut parallel to horizontal. You should then be able to press it all the way down into the angled pocket.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
