Thingiverse
Replicator 2 Extruder Fan Mount
by Deepsiks
43
Downloads
27
Likes
1
Makes
After installing the 3in1 Extruder Upgrade I wanted to get rid of the roof overhang / filament guide tube holder so I downloaded a few fan brackets with no joy upon install. With the few I tried I noticed that the cooling duct was not properly aligning in all and various directions. So I made my own part that gives proper alignment to the cooling duct in relation to the extruder nozzle. It also has allen wrench access holes on top to make installation/ removal much easier.
I use this with the following items:
http://www.thingiverse.com/thing:140254
http://www.thingiverse.com/thing:136423
I use this with the following items:
http://www.thingiverse.com/thing:140254
http://www.thingiverse.com/thing:136423
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!