Replicator 2X bearing block

This is the left hand bearing block for a Replicator 2X.
Mine wore out where the pulley shaft meets the block, so I decided to print one on my Taz 6

The slip bearings are held in place with a rubber O-Ring. I will be adding a retainer plate to both ends to help secure the bearing in its seat.

Designed with Solid Works.


Update: 10/06/2016

Revision 1.1

The offset between the timing belt clamps was off.

I changed the offeset for the timing belt clamps
Also made the clamps a bit thicker for rigidness...

Rev. 1.2

Just cleaned some edges up and beefed up the belt clamps