Replicator 2X Filament Guide Tube

I previously made a new spool holder because the stock one that comes with the Replicator 2X binds up and causes the prints to fail. This is the one I made:

https://www.thingiverse.com/thing:53780

After printing and setting these up, I found that the spools were farther away from the back of the printer and the filament took a sharp bend to get to the filament tube attached to the back of the printer and sometimes caused a loose spool of material to come out of the spool.

I looked online for existing guide tube options but did not find anything that worked well.
I decided to build one from scratch despite having little knowledge to do so. I used TinkerCad to make the 4 different parts. For the tube guides, I decided to make them from NinjaFlex because I wanted to bend the tubes slightly out at the end and i had the filament but never used it before. I mirrored the first tube I made to create the second tube side. My existing plastic tubes fit into the NinjaFlex parts and th