Thingiverse
Replicator 2x Y Stepper Bracket
von tempo502
53
Downloads
31
Likes
0
Makes
I wanted to replace my injection-molded ABS Y stepper bracket with polycarbonate for better heat resistance, so I modeled this up. Nothing fancy.
It's a little thinner than stock so you have room to install a cork gasket or stepper damper if you want.
It's a little thinner than stock so you have room to install a cork gasket or stepper damper if you want.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!