Thingiverse
Replicator HBP Washer Constraints
von GeraldO
10
Downloads
10
Likes
0
Makes
A set of 4 constraints for the Replicator's HBP washers.
It can be a real chore to keep them all aligned when removing and replacing the HBP and this will ensure that all of the washers are aligned during assembly and will not shift during operation. There is ~1mm of tolerance with the washers on my Replicator and a few millimeters of clearance when the springs are fully compressed.
*NOTE* It seems that newer replicators are shipping without these washers under the springs making this system unnecessary. Awesome!
It can be a real chore to keep them all aligned when removing and replacing the HBP and this will ensure that all of the washers are aligned during assembly and will not shift during operation. There is ~1mm of tolerance with the washers on my Replicator and a few millimeters of clearance when the springs are fully compressed.
*NOTE* It seems that newer replicators are shipping without these washers under the springs making this system unnecessary. Awesome!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
