RepRack x Gridfinity Shelf Adapter

Allows you to snap-mount a 5-deep Gridfinity Screw Together Baseplate onto a RepRack installation. Organize all the things! Printing and AssemblyFor a standalone shelf installation - print a pair of siderails.For side-by-side installation (with 3mm gap) - print siderails, and as many midrails as needed.Print one of Kyle Warren's screw-together baseplates (must be 5-deep, and however wide you want)Then mount siderails onto the sides.Snap-fit over the ½" EMT conduit rails on your Reprack shelfModel Design NotesOpted to make this design a bolt-on addition to Kyle Warren's baseplate so that if you change your RepRack setup and no longer have need for a shelf, you can remove the rails and reuse the baseplate.Future DevelopmentPotentially revising the design -or- adding on additional components to give a vertical dimension and allow the use of baseplates as drawers on sliders.Potentially adding screwholes so that the shelf rails can act almost like drawer slides at a fixed width.