Thingiverse
Reprappro Mendel E3D Mount
door plexer
8
Downloads
2
Likes
0
Makes
Carriage plate and adaptors to fit an e3d v6 lite hotend to a ReRapPro Mendel printer.
Added new versions to give more clearance to hot end heater block as it was in danger of melting the carriage plate.
1B version moves hotend down another 5mm as my x axis rods were very close to the bed.
Bottom clamp goes against the carriage plate as this one is slightly taller than the top clamp to give more spacing.
Modified the carriage mount to move the extruder down another 5mm for clearance of bed clips and also added and arm which will depress the x carriage endstop.
Added new version as experiment to hold 20mm piezo disc for z probe, use nozzle mount front 1d and the top and bottom piezo clamp pieces.
Pictures and resting results to come once I receive my kit from precision piezo.
Added new versions to give more clearance to hot end heater block as it was in danger of melting the carriage plate.
1B version moves hotend down another 5mm as my x axis rods were very close to the bed.
Bottom clamp goes against the carriage plate as this one is slightly taller than the top clamp to give more spacing.
Modified the carriage mount to move the extruder down another 5mm for clearance of bed clips and also added and arm which will depress the x carriage endstop.
Added new version as experiment to hold 20mm piezo disc for z probe, use nozzle mount front 1d and the top and bottom piezo clamp pieces.
Pictures and resting results to come once I receive my kit from precision piezo.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
