Resin Print Curing Box

A curing box that can fit the entire print volume of my Epax X1 (or similar photon/mars). The door is magnetic, embedded are 16x2.5MM neodymium magnets I actually got at Daiso Japan, but 16x2mm magnets should work if you can't find those. The magnets attract to some m5 screws (2). You will want some kind of foil tape or something reflective to line the inside of the box (or at minimum print the box white), I just used aluminum foil tape.

The body ended up being just over 700G when sliced and printed, make sure you use an almost new spool and make sure that it has good adhesion to your bed, you don't want curling.

I used the following parts from amazon and some hardware I had on hand.

[Switch](https://www.amazon.com/gp/product/B07D27BJFY/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1)

[Power Jack](https://www.amazon.com/gp/product/B01GBW8J8A/ref=ppx_yo_dt_b_asin_title_o01_s01?ie=UTF8&psc=1)

[UV LED](https://www.amazon.com/gp/product/B07K788YLM/ref=ppx_yo_dt_b_asin