Thingiverse
Resin printer air filter
von MakeinSarawak
30
Downloads
11
Likes
0
Makes
Just a small air filter to go through the back of a resin printer to reduce the smell.
Uses a 65x65x20mm activated charcoal filter, available at a lot of pet stores or online hardware stores mostly used as solder fume extractor filters.
Fan can be spliced onto an existing fan or into a header on the board depending on what is available.
Will need 2x Gasket model, one in front and one after the fan.
The gasket 2 model can be up scaled to increase the thickness to fit the size of the wall of the printer. (Currently set for 4mm thick wall)
Uses a 65x65x20mm activated charcoal filter, available at a lot of pet stores or online hardware stores mostly used as solder fume extractor filters.
Fan can be spliced onto an existing fan or into a header on the board depending on what is available.
Will need 2x Gasket model, one in front and one after the fan.
The gasket 2 model can be up scaled to increase the thickness to fit the size of the wall of the printer. (Currently set for 4mm thick wall)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
