ResinWash

This is a resin wash machine for clean uv resin prints

List of parts you would need.

1- Container 5x5'' size

8- Magnets 10mm

1- 120 mm case fan with the propellers cut

1- Potentiometer 1 turn 10k

1- Resistance 470 ohms

1- MOSFET canal N 50N06

1- Bearing 608zz

1- Female Panel Mounting Connector

1- 12v power adapter

Building instruction

-Apply glue to the top of the fan and attach the fan cap
-Place 4 magnets on the Magnets holder facing up and 4 magnets on the Impeller in
the same way, question that both parts repel each other, attach the magnets holder to the
fan cap with a screw.
-Wire parts using included diagram
-Attached your wired parts to your printed Main parts.
-Attach oiled 608zz to the Impeller to the bottom of your Impeller basket

Always start the fan slowly when starting

This parts are remixed from https://www.thingiverse.com/thing:4130767
-Impellering
-Fan Cap
-Magnets holder
-Impellering_Top



MOSFET canal N 50