Resistance Band Wall Loop

This has to be printed and hung in a specifc way. The first is that you cannot reduce the infil, otherwise the plastic will just break super easy. There is still a risk that the plastic will break, but the way it is built and printed minimize that risk drastically. The 60% infill is vital to make it a very sturdy part. Learning About Infill Percentage CompressionLearning About Infill Choice Strength where Gyroid has the most uniform strengthAdditionally, the thinner piece goes towards the top while the thicker goes towards the bottom. This is so that the bulk of the pressure and poundage goes unto the portion that is bigger. The piece will have the strongest strength against forces pulling straight down.The second is it has to be hung in a specific way. You cannot hang this in any-old place, it needs to be hung into the wood located by the studs. If you put this in the drywall area, it's likely to rip out your drywall. This is why you need to find the wood part of your wall and scr