Thingiverse
respirator junction
di scoobie975
11
Download
5
Likes
0
Makes
Used to attach a small oxygen feed into a respirator or CPAP.
Not tested. Use at your own risk.
Printed at 220C with 110% flow for better layer adhesion.
Print horizontally with the small pipe coming out at 45 degrees sideways for added strength.
I also cleaned up the inside of the small pipe with a drill.
Finish with fine sandpaper.
Not tested. Use at your own risk.
Printed at 220C with 110% flow for better layer adhesion.
Print horizontally with the small pipe coming out at 45 degrees sideways for added strength.
I also cleaned up the inside of the small pipe with a drill.
Finish with fine sandpaper.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!