Cults3D
Tool
Ver Modelo
Retraction / Stringing tower test with temperature set
857
Descargas
11
Likes
0
Makes
I tested some of the retraction and stringing test here, there are good ones, but i wanted to create my own one with the idea of an economic to print and simple two tower desing.
Also I wanted the temperature ranges were visible enough, but maintaining the size of the towers small and slim.
I created a set of preset towers with a 25 degrees range (covering the most common materials), one without temp texts (to allow someone editing the mesh to customize it for another specific range of temps), and finally one with a 50 degrees range just in case.
The tower is just 30mm tall and 33mm long. Anyway, I added one photo with some dimensions.
Also I wanted the temperature ranges were visible enough, but maintaining the size of the towers small and slim.
I created a set of preset towers with a 25 degrees range (covering the most common materials), one without temp texts (to allow someone editing the mesh to customize it for another specific range of temps), and finally one with a 50 degrees range just in case.
The tower is just 30mm tall and 33mm long. Anyway, I added one photo with some dimensions.
Ivan111 también publica en
7 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
