Thingiverse
Retraction Test
von phunnymaniac
12
Downloads
4
Likes
0
Makes
I tried a "retraction test" I found on here. Thought I had my settings dialed in good, until I went to print a big item with a good amount of travel distance. It was string city. I made this to test with distances.
I will note that you should scale it to your liking. It's bigger than I anticipated, and I had to scale it down for my printer. Estimated print time at 50% scale is 20 minutes at 60mm/s.
I will note that you should scale it to your liking. It's bigger than I anticipated, and I had to scale it down for my printer. Estimated print time at 50% scale is 20 minutes at 60mm/s.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
