Thingiverse
Retrocase_v1.0
door alystor
0
Downloads
0
Likes
0
Makes
This is a case for Retrostone and it is designed from ground up following the original case dimensions.
I've printed the front with supports just in the buttons regions with a 0.6mm nozzle and 0.3 layer height using PETG filament. Back side does not need any support.
I would would still recommend using 0.45mm nozzle with a 0.2 layer height for best results.
Case does not have back buttons support but those could be easily added.
This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/ca4qEFbAzGm
I've printed the front with supports just in the buttons regions with a 0.6mm nozzle and 0.3 layer height using PETG filament. Back side does not need any support.
I would would still recommend using 0.45mm nozzle with a 0.2 layer height for best results.
Case does not have back buttons support but those could be easily added.
This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/ca4qEFbAzGm
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
