Retroflag GPi Case DPad
door kendonmcb
13
Downloads
4
Likes
0
Makes
DPad for the Retroflag GPi Case, with a tighter fit than the original DPad which is somewhat loose.
Printed upright (the "pin" pointing downwards with supports around it) with default settings on the DaVinci Minimaker with XYZPrinting app it is a bit of a tight fit, but much better than the original. Printed at 98% it is as I would say it should have been from the factory, perfect fit with just enough movement.
Printed upright (the "pin" pointing downwards with supports around it) with default settings on the DaVinci Minimaker with XYZPrinting app it is a bit of a tight fit, but much better than the original. Printed at 98% it is as I would say it should have been from the factory, perfect fit with just enough movement.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!