Thingiverse
Retropia Lens Cap
0
Download
4
Likes
0
Makes
A little bit of protection for the delightful Retropia® lens - get yours at https://retro-pia.com/
The cap clips on securely and can rotate around the lens.
Print with 0.2mm (or less) layer height and ensure the central cylinder forms cleanly as there is not much clearance around that part of the lens. Prints without supports.
Check out more things by Department_Nine!
Retropia is a registered trademark of Sky Carousel Inc. I think... please advise if that's wrong and I'll correct.
The cap clips on securely and can rotate around the lens.
Print with 0.2mm (or less) layer height and ensure the central cylinder forms cleanly as there is not much clearance around that part of the lens. Prints without supports.
Check out more things by Department_Nine!
Retropia is a registered trademark of Sky Carousel Inc. I think... please advise if that's wrong and I'll correct.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!